RELAG98GBD

[ Pobierz całość w formacie PDF ]

��SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL
RENAULT LAGUNA 98 �! DIESEL
�!
MAKE MOD. YEAR
X
ALARM/SIREN Position the compact alarms and the sirens on the left of the engine compartment, on
the lateral panel.
POSITION
POWER SUPPLY + 30: connect to the 4 mm2 RED wire located in the general power supply multiway
connector of the fuse box.
- 31: connect with a cable terminal to one of the ground terminals located behind the
lateral panel, driver s side.
IGNITION WIRE + 15/54: connect to the wire at the position A1 (the first on the right of the little fastons)
of the 1st connector on the left, coming out of the central doors locking unit located on
the left of the dashboard, driver s side.
DIRECTION INDICATORS Connect to the VIOLET/WHITE wire at the position nr. A7 and to the GREEN wire at
the position A5 of the connector coming out of the lights switch.
ELECTRIC WINDOWS Positive control signal
Front window, driver s side:
cut the GREY wire at the position B5 of the 9 way black connector located inside the
driver s side door.
Front window, passenger s side:
cut the WHITE wire located in the wiring harness coming out of the driver s side door.
Rear window, driver s side:
cut the WHITE/BLACK wire coming out of the respective control switch.
Rear window, passenger s side:
cut the WHITE/RED wire directly coming out of the respective control switch.
The wires are in the wiring harness coming out of the respective switches.
CENTRAL DOORS LOCKING Negative control signal
Connect to the ORANGE wire (lock) and to the VIOLET wire (unlock) located in the
wiring harness coming out of the connector of the original lock/unlock switch.
Alternatively connect the same wires at the positions B2 and B1 in the wiring harnes
coming out of the 13 way black connector of the central doors locking unit under the
dashboard, driver s side.
IMMOBILISATION POINT Gasoil pump
Cut the YELLOW wire located at the position nr. 2 of the brown connector, near the
fuse box.
BONNET SWITCH Install an additional switch on the front headlamp support plate, near the original
rubber bonnet stop.
DOORS SWITCH Connect to the 0,5 mm2 BROWN wire located at the position nr.4 of the connector
marked R2 coming out of the left support, driver s side.
BOOT SWITCH Connect directly to the wire of the boot lamp coming out of the same.
relag98gbd.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual. [ Pobierz całość w formacie PDF ]

Tematy